SiBE01-503 Instructions
System Configuration 43
2.8 Care and Cleaning
16
Care and Cleaning
CAUTION
■
Indoor unit, Outdoor unit and Remote controller
1. Wipe them with dry soft cloth.
■
Front panel
1. Open the front panel.
•
Hold the panel by the tabs on the two sides and lift
it unitl it stops with a click.
2. Remove the front panel.
•
Supporting the front panel with one hand, release
the lock by sliding down the knob with the other
hand.
•
To remove the front panel, pull it toward yourself
with both hands.
3. Clean the front panel.
•
Wipe it with a soft cloth soaked in water.
•
Only neutral detergent may be used.
•
In case of washing the panel with water, dry it with
cloth, dry it up in the shade after washing.
4. Attach the front panel.
•
Set the 3 keys of the front panel into the slots
and push them in all the way.
•
Close the front panel slowly and push the
panel at the 3 points.
( 1 on each side and 1 in the middle.)
•
Check to see if the rotating axis in the upper
center section is moving.
CAUTION
Units
•
Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 40˚
C, benzine, gasoline, thinner, nor other volatile oils, pol-
ishing compound, scrubbing brushes, nor other hand stuff.
•
After cleaning, make sure that the front panel is securely fixed.
Before cleaning, be sure to stop the operation and
turn the breaker OFF.
Fit the key
into the slot.
To Next Page
Loading...
Need help?
General
