16
Installation
1. Install the 2-way valve kit as indicated in the pictures of gure 3. (For right pipe connection unit.) As
shown as detail A, rstly take apart connector, then install ① to unit with necessary sealing material . Fix
② between ① and ③. At last tighten ③, make sure all of connectors are sealed.
2. Install the 3-way valve kit as indicated in the pictures of gure 4. (For right pipe connection unit.) Detail is
as same as 2-way valve unit.
The valve kit has been pre-assembled for easy installation.
• Where needed the connections are pre-coated with sealing material.
• The connections are not tightened for easy adjustment.
• After determining the nal position of the valve kit, tighten all connections to obtain water tightness.
220
203
146
65
209
WATER RETURN CONNECTION Rc3/4
WATER SUPPLY CONNECTION Rc3/4
Figure 3 2-Way Valve
A
Detail A
ķ
ĸ
Ĺ
153
218
300
120
210
A
Detail A
ķ
ĸ
Ĺ
WATER SUPPLY CONNECTION Rc3/4
WATER RETURN CONNECTION Rc3/4
To Next Page
