Operation Manual SiBE611027_A
25 Operation Manual
Airflow selection
13
Airflow selection
• Make airflow selection according to what suits you.
When setting the airflow selection switch to .
When setting the air outlet selection switch to .
CAUTION
Mode Situation Blowing pattern
COOL
HEAT
• Unit automatically decides the appropriate blowing pattern depending on the operation
mode/situation.
• When the room has become
fully cool, or when one hour has
passed since turning on the unit.
• At start of operation or other times
when the room is not fully cooled.
• At times other than below.
(Normal time.)
• At start or when air temperature
is low.
• So that air does not come into direct
contact with people, air is blown upper
air outlet, room temperature is equalized.
• Air is blown from the upper and lower air
outlets for high speed cooling during
COOL operation, and for filling the room
with warm air during HEAT operation.
• Regardless of the operation mode or situation, air blows from the upper air outlet.
• Use this switch when you do not want air coming out of the lower air outlet. (While sleeping etc.)
• Do not try to adjust the flap by hand.
• When adjusting by hand, the mechanism may not operate properly or condensation may
drip from air outlets.
• So that air does not come into direct
contact with people. Air is blown upper
air outlet.
To Next Page
Loading...
