Operation Manual SiBE81-623A
24 Photocatalytic Air Purifiers
13
Care and Cleaning
CAUTION
• When cleaning the unit, be careful not to cut your hands with the
opposing pole plate or ionizer wires.
(It is safer to use rubber gloves.)
• When cleaning the unit, be careful not to cut the ionizer wires.
• Be sure to do in a shower-proof place such as bathroom or sink in a
kitchen.
• Use only specified volume of liquid mild detergent.
• Do not use powder detergent or alkaline detergent and scrub with
hard sponge. Distortion or damage to the equipment may result.
Cleaning the plasma ionizer
1) Ionized wire (8 pieces)
• Clean off the ionizer wires and peripheral resin part with a soft
cloth.
2) Streamer discharger
• Clean off the internal resin part with a soft cloth.
(For removal, see page 11.)
3) Ionizing frame
• Clean off the resin part with a soft cloth.
• Use a cotton bud to wipe off dirt of odd-shaped area where
your finger does not reach.
• Be careful not to leave bits of tissue. Malfunction may result.
NOTE
If the ionizer wires are cut;
Replacement is necessary. Contact your dealer.
* Gently wipe off the ionizer wires.
Pulling hard may cut them.
: Resin part *1
*1 Wipe off only the resin part.
*2 Do not touch the discharge needle.
Bending the needle will reduce
deodorizing performance.
Discharge
needle
*2
Cotton bud
* Use a cotton bud to wipe off dirt
of odd-shaped area.
2) Streamer discharger1) Ionized wire
3) Ionizing frame
To Next Page
Loading...
Need help?
General
