62 AGZ 025D through 190D OMM 1087
LCD Display
Table 16, Display Data
No Name Display Content
MODE
Displayed when in Mode Selection.
MONITR
Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
1
Operation
Mode Menus
SETUP Displayed when in Setup Mode.
2
DriveWorksEZ
Function
Selection
DWEZ Displayed when DriveWorksEZ is set to enable. (A1-07 = 1 or 2)
DRV Displayed when in Drive Mode.
3
Mode Display
Area
PRG Displayed when in Programming Mode
4 Ready Rdy Indicates the drive is ready to run.
5 Data Display —
Displays specific data and operation data.
OPR
Displayed when the frequency reference is assigned to the LCD Operator
Option.
AI
Displayed when the frequency reference is assigned to the Analog Input of the
drive
COM
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus
CommunicationInputs of the drive
OP
Displayed when the frequency reference is assigned to an Option Unit of the
drive.
6
FrequencyRefe
rence
Assignment
<1>
RP
Displayed when the frequency reference is assigned to the Pulse Train Input of
RSEQ Displayed when the run command is supplied from a remote source.
LSEQ Displayed when the run command is supplied from the operator keypad.
RREF Displayed when the run command is supplied from a remote source.
7
LO/RE Display
<2>
LREF Displayed when the run command is supplied from the operator keypad
JOG Pressing [F1} executes the Jog function.
HELP
Pressing [F1] displays the Help menu.
← Pressing [F1] scrolls the cursor to the left.
HOME
Pressing [F1] returns to the top menu (Frequency Reference).
8
Function Key
1(F1)
ESC Pressing [F1] returns to the previous display
FWD Indicates forward motor operation.
9 FWD/REV
REV
Indicates reverse motor operation.
FWD/REV Pressing [F2] switches between forward and reverse
DATA Pressing [F2] scrolls to the next display
Pressing [F2] scrolls the cursor to the right
10
Function Key 2
(F2)
RESET Pressing [F2] resets the existing drive fault error