Daikin MPS040 F - Appendix - Keypad;Display Menu Structure; Figure 103: Optional Outdoor Air Monitor - Set Up Menu

Figure 103: Optional Outdoor Air Monitor – Set Up Menu
Press and release ↑/↓ during normal operation to select
IP/SI Units ↓
Set Up ↓↑
LCD1 U/M=FPM ↓
1
LCD1 U/M=FPM ↓
Set LCD1 Units? Set Area1? Set Out1 Units?
2
Set Out1? Set FS1?
LCD1 U/M=CPM ↑
AR1=0.00SQF ↑
1
AR1=0.000 SQF ↓↑
OUT1 U/M=FPM ↓
1
OUT1 U/M=FPM ↓↑
2
OUT1=0–10V ↓
OUT1 U/M=CPM ↑
2
OUT1=0–5V ↓↑
FS1=5000FPM ↓↑
FS1=10000FPM for GF1
or
FS1=5000CFM ↓↑
FS1=10000CFM for GF1
1
FS1=5000FPM ↓↑
1
FS1=10000FPM for GF1
or
1
FS1=5000CFM ↓↑
1
FS1=10000CFM for GF1
2
OUT1=4–20mA ↑
1
OUT1=4-20mA ↓↑
See Figure 102: System
Units Menu, page 129
Enter (Move →)
Esc (Normal Operation)
Enter (Move →)
Esc (Move ←)
Enter (Move →)
Esc (Move ←)
Enter (Action, Move →→)
Esc (Move ←←)
Visible only when LCD U/M=CFM
FS1 units determined by
OUT1 U/M setting
Displays airow in FPM. Outputs airow in FPM.
In addition, “SW1” must be set
to the VDC position to change
airow output to 0–10VDC.
In addition, “SW1” must be set
to the VDC position to change
airow output to 0–5VDC.
In addition, “SW1” must be set to
the mA position to change airow
output to 4–20mA.
Set area between
0.00 and 999.99 sq.ft. Area
affects the LCD display reading
and output when set for CFM.
Fullscale analog output value
from 100 to 15,000 for FPM
(up to 999,999 for CFM) in
increments of 1.
Value must be ≥ LL1 + 10 or, if
LL1=0, value must be ≥ 100.
Displays airow in CFM (User
must input AR1 area.
Outputs airow in CFM (User
must input AR1 area.
IM 1058-8 • MAVERICK II ROOFTOP SYSTEMS 130 www.DaikinApplied.com
aPPendIx – keyPad/dIsPlay menU sTrUCTUre