Daikin Perfera FVXM A Series - Page 144

3 | Components
Service manual
144
RXM20~71R + ARXM25~71R + FTXM20~71R + ATXM25~50R +
FVXM25~50A
Split New Perfera R32
ESIE20-11 – 2021.01
b DC fan motor harness
c Switch box
d Screw
e DC fan motor assy
8 Detach the DC fan motor harness from the switch box.
9 Slightly bend the harness retainers (if applicable) to detach the DC fan motor
harness.
10 Remove the 4 screws that fix the DC fan motor assembly.
11 Remove the DC fan motor assembly from the unit.
12 To install the DC fan motor assembly, see "Repair procedures"[4142].
To install the DC fan motor assembly
1 Install the DC fan motor assembly in the correct location.
2 Fix the DC fan motor assembly to the unit by tightening the screws.
3 Route the DC fan motor harness through the harness retainers and bend the
harness retainers to attach the DC fan motor harness.
4 Attach the DC fan motor harness to the switch box.
5 Install a new tie strap to fix the DC fan motor harness to the switch box.
6 Connect the DC fan motor connector to the connector on the main PCB.
7 Lock the ferrite bead.
e dd
a c
b
a DC fan motor connector
b DC fan motor harness
c Switch box
d Screw
e DC fan motor assy
8 If applicable: Route the DC fan motor harness through the harness retainers
and bend the harness retainers to attach the DC fan motor harness.
9 Route the DC fan motor harness upwards and attach the DC fan motor
harness to the switch box.
10 Connect the DC fan motor connector to the connector on the main PCB.
11 Install the propeller fan blade assembly, see "Repair procedures"[4142].
To install the propeller fan blade assembly
1 Install the propeller fan blade assembly on the DC fan motor assembly.
CAUTION
Do NOT install a damaged propeller fan blade assembly.
2 Install and tighten the nut to fix the propeller fan blade assembly.