FLN-D
Installation Diagram
Indoor Unit
Outdoor Unit
Air Discharge Louver
Wrap the insulated pipe with
finishing tape from bottom to top
Signal Receiver Indicator Lights
Air Discharge Grille
Air Intake Grille
Air Filters
(Inside Air Intake Grille)
Air Intake
Air Intake
Air Discharge
Installation Of The Indoor Unit
Figure A
C
D
F E
B
JH
A
G
L
K
Preliminary Site Survey
• Electrical supply and installation shall conform
to the local authority (e.g. National Electrical
Board).
• Voltage supply fluctuation must not exceed
±10% of the rated voltage. Electricity supply
lines must be independent of welding
transformers which can cause high supply
fluctuation.
• Ensure that the installation location is
convenient for wiring and piping.
Standard Mounting
Ensure that the overhead supports are strong
enough to hold the weight of the unit. Position
the hanger rods (wall mounting bracket for floor
standing), and check for its alignment with the
unit as shown in Figure A. Also, check that the
hangers are secured and the base of the fan coil
unit is leveled in both horizontal directions,
taking into account the gradient for drainage
flow as recommended in Figure B.
All dimensions are in mm/(in)
Dimensions
A B C D E F G H I J K
1714 666 273 130 1636 39 - - - - -
1714 666 273 130 1636 39 - - - - -
Model
FLN40DV1L
FLN40DV1M
FLN50DV1L
FLN50DV1M
To Next Page
Loading...
