EasyManua.ls Logo

Daikin Rebel Applied DPSA - Step Controller Troubleshooting

Daikin Rebel Applied DPSA
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IM 1287-6 • REBEL APPLIED ROOFTOP 118 www.DaikinApplied.com

Step Controller Troubleshooting
Figure 182: Step Controller Troubleshooting Instructions
FUNCTIONAL TEST DESCRIPTION:
The nal test m can be use t verify  era stage sengs an in signal. This m will byass th the
inter-stage lay  an ut signal in rer t sequence the stages ring t the current status  the STAGE  The
test sequence will al  the  signal.
The ar
is cgure  the  test m by se switch 5 t ‘TEST’. When the r is   in the 
test e the  sequence  events will take ce:
1. The  LEDs will illuminate n wer u an remain  ng the cy
cling u an   the stages:
LED
Master Unit Slave Unit
De Number 
 LED 1 Re On On
Err LED 2 Yew On O
Run LED 3 Green On On
Fault LED 4 Yew On O
DC  LED 10 Re On On
Vernier LED 11 Green On O
Slave LED 12 Green On On
2. The stage LED lights will cycle  an then  in a linear fash   last  ing the number  stages currently
set. Bth the inter-stage lay  an ut signal are bye ring this test.
3. r the stage cycling is mlete the ctrer will  a test t ve
rify the  signal. All lights exce the DC
 (LED 10 will turn  an ne  the  lights will blink t cnclue the funcnal test:
LED
De  t test result if LED is 
De Number 
 LED 1 Re  rity (mA  VDC
Err LED 2 Yew N  signal etecte  signal etecte is t  range *
Run LED 3 Green N issues. Vali  signal etecte.
*   +10% / -5% n range limit 
4. r test is cmete er   an set switch 5 back t ‘Ctr’. The  is reay t ut int service.
If the light sequence wn is t as t base n the current setu   verify segs an
cntact
factry  assistance.
CAUTION:
- Dinnect all er  changing any  

Related product manuals