Daikin Rebel Applied DPSA - Rebel Applied Equipment Warranty Registration Form; III. START-UP COMPRESSOR OPERATION; IV. PERFORMANCE DATA


www.DaikinApplied.com 175 IM 1287-6 • REBEL APPLIED ROOFTOP
Rebel Applied Equipment Warranty Registration Form
Select Yes or No. If not applicable to the type of unit, select N/A.
13F-41577
3
. .
. .
. .
. .
. .
_______
III. START-UP COMPRESSOR OPERATION
A. Do compressors have holding charge? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B. Are compressor shipping brackets removed? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C. Are compressors rotating in the right direction? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
D. Do condenser fans rotate in the right direction? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
E. Ambient temperature (°F): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Yes No
Yes No
Yes No
Yes No
. . . . . . . . _
N/A
N/A
N/A
N/A
_
IV. PERFORMANCE DATA
A. Compressor voltage across each phase: . . . . . . . . . 1–2 V 2–3 V 1–3 V
B. Compressor amperage of fully loaded compressor: Compressor #1 — Phase 1 Phase 2 Phase 3
Compressor #2 — Phase 1 Phase 2 Phase 3
Compressor #3 — Phase 1 Phase 2 Phase 3
Compressor #4 — Phase 1 Phase 2 Phase 3
Compressor #5 — Phase 1 Phase 2 Phase 3
Compressor #6 — Phase 1 Phase 2 Phase 3
C. Discharge pressure, one compressor: . . . . . . . . . . . . . . . . . . . . . Circuit 1 psig Circuit 2 psig
D. Suction pressure, one compressor: . . . . . . . . . . . . . . . . . . . . . . Circuit 1 psig Circuit 2 psig
E. EVI percentage , one compressor: . . . . . . . . . . . . . . . . . N/A Circuit 1 % Circuit 2 %
F. Discharge pressure, fully loaded, 2–3 compressors: . . . . . . . . . . . . . Circuit 1 psig Circuit 2 psig
G. Suction pressure, fully loaded, 2–3 compressors: . . . . . . . . . . . . . . . Circuit 1 psig Circuit 2 psig
H. Liquid press, fully loaded, 2–3 compressors (at liquid line shutoff valve): . . . Circuit 1 psig Circuit 2 psig
I. Liquid temperature, fully loaded, 2–3 compressors: . . . . . . . . . . . . . . Circuit 1 psig Circuit 2 psig
J. EVI percentage, fully loaded, 2–3 compressors: . . . . . . . . . . N/A Circuit 1 % Circuit 2 %
L. Suction line temperature: . . . . . . . . . . . . . . . . . . . . . . . . . . . Circuit 1__________°F Circuit 2 ___________°F
M. Superheat: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Circuit 1__________°F Circuit 2 ___________°F
N. Subcooling:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Circuit 1__________°F Circuit 2 ___________°F
O. Discharge superheat:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Circuit 1__________°F Circuit 2 ___________°F
P. Did unit control DAT to DAT setpoint? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes No N/A
Q. Is the liquid line in the line sightglass clean and dry?
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes No N/A
R. Record discharge air temperature at discharge of unit…………………………………………………………………………: °F