www.DaikinApplied.com 25 IM 1287-6 • REBEL APPLIED ROOFTOP
Installation
WARNING
Sharp edges on sheet metal and fasteners can cause personal injury.
Please wear appropriate personal protective equipment (PPE) such as
gloves, protective clothing, footwear, eye protection, etc. This equipment
must be installed, operated, and serviced only by an experienced installation
company and fully trained personnel.
The installation of this equipment shall be in accordance
with the regulations of authorities having jurisdiction and all
applicable codes. It is the responsibility of the installer to
determine and follow the applicable codes.
NOTICE
Unit/equipment must be installed in a location that is not accessible to the
general public.
Receiving Inspection
When the equipment is received, all items should be carefully
checked against the bill of lading to be sure all crates and
cartons have been received. If the unit has become dirty during
shipment (winter road chemicals are of particular concern),
clean it when received.
All units should be carefully inspected for damage when
received. Report all shipping damage to the carrier and le a
claim. In most cases, equipment is shipped F.O.B. factory and
claims for freight damage should be led by the consignee.
Before unloading the unit, check the unit nameplate to make
sure the voltage complies with the power supply available.
Remove all shipping protection prior to installation.
Unit Clearances
Service Clearance
Allow service clearance as indicated in Figure 35 or Figure
36. Figure 35 denotes clearances required if large component
replacement would be completed through side access doors.
Figure 36 denotes clearances needed if large component
replacement would be completed from the top of the unit
(with a crane) after removing roof panels. Also, Daikin Applied
recommends providing a walkway around the entire unit for
access to controls and serviceable components.
Compliance Statements
Depending on the unit conguration, the unit will come with
either a Fused Disconnect, a Non-Fused Disconnect, a power
block, or a combination in cases where multiple sources
of power are specied. Consult the Unit Specic Electrical
Schematics to determine the number of required sources of
power. Refer to Table 7 on page 66 for the standard multiple
point power connection options and their function.
Children should be supervised to ensure that they do not play
with the appliance.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory, or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
To Next Page
Loading...
