To Next Page
C
Christian SilvaSep 7, 2025
What to do if there is a burning smell coming from my Daikin RKS35BVMB Air Conditioner?
- MMelissa MackSep 7, 2025
Turn the breaker OFF.
What to do if there is a burning smell coming from my Daikin RKS35BVMB Air Conditioner?
Turn the breaker OFF.
Why does my Daikin Air Conditioner operation does not start soon?
You should wait for about 3 minutes.
Why hot air does not flow out soon after I start heating operation of my Daikin RKS35BVMB?
You should wait for 1 to 4 minutes.
Why does my Daikin RKS35BVMB outdoor unit emit water or steam?
In HEAT mode, the frost on the outdoor unit melts into water or steam when the air conditioner is in defrost operation. In COOL or DRY mode, moisture in the air condenses into water on the cool surface of outdoor unit piping and drips.
Why Daikin RKS35BVMB is not turning on? (OPERATION lamp is off)
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: * Ensure the breaker hasn't been turned OFF or a fuse hasn't blown. * Verify that there isn't a power failure. * Confirm that batteries are correctly installed in the remote controller. * Check if the timer setting is correct.
Why is the cooling or heating effect poor in my Daikin RKS35BVMB Air Conditioner?
Several factors can cause a poor cooling or heating effect. Ensure the air filters are clean. Check for any obstructions blocking the air inlet or outlet of both the indoor and outdoor units. Verify that the temperature setting is appropriate for your needs. Confirm that all windows and doors are closed tightly. Finally, make sure the airflow rate and direction are set correctly to optimize cooling or heating.
Why hot air does not flow out soon after starting heating operation on my Daikin RKS35BVMB?
If hot air does not flow out soon after you start the heating operation on your Daikin air conditioner, you should wait for 1 to 4 minutes.
How to fix Daikin RKS35BVMB operation that does not start soon?
If your Daikin Air Conditioner operation does not start soon, you should wait for about 3 minutes.
Why does Daikin Air Conditioner release mists from the indoor unit?
Mists may come out of the indoor unit of your Daikin Air Conditioner when the air in the room is cooled into mist by the cold airflow during cooling operation.
Why Daikin Air Conditioner heating operation stops suddenly and a flowing sound is heard?
If the heating operation on your Daikin Air Conditioner stops suddenly and you hear a flowing sound, the system is likely removing frost from the outdoor unit. Wait for about 3 to 8 minutes.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Heating Capacity | 4.0 kW |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 9 kg |
| Refrigerant | R32 |
| Indoor Unit Weight | 9 kg |
Lists functions specific to the Cooling Only operation mode.
Lists functions specific to the Heat Pump operation mode.
Technical specifications for the Cooling Only models.
Technical specifications for the Heat Pump models.
Wiring diagram for the indoor unit's PCB and connectors.
Wiring diagram for the outdoor unit's PCB and connectors.
Explains how the inverter controls compressor frequency for capacity regulation.
Describes the human motion sensor function for energy saving.
Explains the function for recording and recalling preferred settings.
Outlines the hierarchy of operating modes and their priorities.
Details the logic for determining compressor frequency based on conditions.
Lists common malfunctions and their potential causes.
Outlines critical safety precautions for system handling and installation.
Identifies and names the key components of the indoor and outdoor units.
Provides essential cautions before performing diagnostic procedures.
Lists error codes and their descriptions for quick fault identification.
Lists error codes and their descriptions for quick fault identification.
Step-by-step guide for removing the air filter from the indoor unit.
Procedure for removing the front grille of the indoor unit.
Procedure for removing the external casing of the outdoor unit.
Steps for removing the PCB and electrical box from the outdoor unit.
Instructions for performing a test run using the remote controller.
Piping diagrams for the indoor units.
Piping diagrams for the outdoor units.
Wiring diagrams for the indoor units.
Wiring diagrams for the outdoor units.
