How to fix R410A suction thermistor error (R14T/R24T) on Daikin SEHVX20BAW?
If your Daikin Chiller displays a R410A suction thermistor error (R14T/R24T), check wiring connections. For further assistance, contact your local dealer.
What to do if Daikin Chiller displays a water system warning?
If your Daikin Chiller displays a water system warning, start by inspecting the filter. Also, ensure that all valves are completely open to allow proper water flow. If the problem persists, it may be necessary to seek additional support.
What to do for R410A liquid thermistor error (R13T/R23T) on Daikin Chiller?
If your Daikin Chiller displays a R410A liquid thermistor error (R13T/R23T), check wiring connections. For further assistance, contact your local dealer.
How to troubleshoot R410A expansion valve error (K11E/K12E) in Daikin SEHVX20BAW Chiller?
If you're experiencing issues related to the R410A expansion valve error (K11E/K12E) on your Daikin Chiller, begin by checking the wiring connections to ensure they are properly connected. If problems persist, further investigation might be needed.
How to correct reversed power supply phase malfunction in Daikin Chiller?
If your Daikin Chiller is showing a reversed power supply phase malfunction, correct the phase order to resolve the issue.
How to troubleshoot Heating leaving water thermistor error (R11T/R12T) in Daikin Chiller?
If you're experiencing issues related to the Heating leaving water thermistor error (R11T/R12T) on your Daikin Chiller, begin by checking the wiring connections to ensure they are properly connected. If problems persist, further investigation might be needed.
What to do if Daikin SEHVX20BAW has insufficient refrigerant?
If you suspect insufficient refrigerant in your Daikin Chiller, check if the additional refrigerant charge has been completed correctly. Recalculate the required amount of refrigerant from the piping length and add an adequate amount of refrigerant.
What to do if Daikin SEHVX20BAW Chiller charging aborted?
If the Daikin Chiller displays 'Charging aborted', immediately close valve A. Then, check if the gas side stop valve and the valve of the refrigerant tank are open, and ensure the air inlet and outlet of the indoor unit are not obstructed. Correct any abnormalities and restart the automatic charging procedure.
How to fix refrigerant overcharge in Daikin SEHVX20BAW Chiller?
If your Daikin Chiller is experiencing a refrigerant overcharge, recalculate the required amount of refrigerant based on the piping length and correct the refrigerant charge level by recovering any excessive refrigerant using a refrigerant recovery machine.
How to fix high pressure error (SENPH/S1PH) on Daikin SEHVX20BAW Chiller?
If the Daikin Chiller displays a high pressure error (SENPH/S1PH), check that the circuit does not contain any air, ensure that water flow is possible by opening all valves, verify the water filter is not blocked, and confirm all refrigerant stop valves are open. For further assistance, contact your local dealer.
General| Model | SEHVX20BAW |
|---|---|
| Type | Air Cooled Chiller |
| Cooling Capacity | 20 kW |
| Refrigerant | R-410A |
| EER | 3.1 |
| Power Supply | 400V, 3 Phase, 50Hz |
To Next Page
