SiBE18-821_C RA Indoor Unit
Operation Manual 209
aAirflow
îš„ Airflow selection
CAUTION
Operating mode Blowing pattern
•
•
• Make airflow selection according to what suits you.
When setting the airflow selection switch to .
COOL mode
HEAT mode
Situation
• When the room has become fully
cool, or when one hour has
passed since turning on the air
conditioner.
• At start of operation or other
times when the room is not
fully cooled.
• At start or when air temperature
is low.
• So that air does not come into
direct contact with people, air
is blown upper air outlet, room
temperature is equalized.
• Air is blown from the upper and
lower air outlets for high speed
cooling during COOL mode, and
for filling the room with warm air
during HEAT mode.
• So that air does not come into
direct contact with people. Air
is blown upper air outlet.
• During Dry mode, so that cold air does not come into direct contact with people, air is blown
upper air outlet.
When setting the air outlet selection switch to .
• Do not try to adjust the flap by hand.
• When adjusting by hand, the mechanism may not operate properly or condensation may drip
from air outlets.
• Regardless of the operating mode or situation, air blows from the upper air outlet.
• Use this switch when you do not want air coming out of the lower air outlet. (While sleeping etc.)
• Air conditioner automatically decides the appropriate blowing pattern depending on the operating
mode/situation.
• At times other than below.
(Normal time.)
To Next Page
Loading...
Need help?
General
