1
Dry
Return Setting
●Press Mode button several times until the Dry mode is selected.
* The dry mode may not be available depending on the type of indoor unit.
2
On/Off
●Press On/O button.
The Operation lamp (green) will illuminate and the system will start
operating.
* In Dry mode, the system maintains automatic temperature and fan speed control. Therefore, temperature
setpoint or fan speed settings are not available while the indoor unit is in the Dry mode.
3
●Adjust Air Flow Direction from the main menu (see page 17).
* If the connected indoor unit model does not include oscillating louvers this function will not be available.
4
On/Off
●When the On/O button is pressed again, the system will stop operating
and the operation lamp will turn o.
Note
● To prevent water damage or system failure, do not immediately remove power from the indoor
unit following system operation. Wait at least ve minutes for the condensate pump to nishing
draining residual water from the unit.
Characteristic of Dry mode
The Dry mode dehumidies the space at reduced cooling capacity to prevent the room
temperature from dropping to uncomfortable levels.
Setback
The Setback feature will maintain the space temperature in a specic range during unoccupied periods.
Note
● This function will temporarily start an indoor unit that was previously turned o by the user or turned o from a schedule
event / o timer.
● This function must be enabled by the system installer.
To Next Page
Loading...
