www.DaikinApplied.com 19 IM 1240-4 • INTELLIGENT EQUIPMENT
Antenna Installation
NOTE: Only one of the two included antennas will be
installed and connected to the M2M Gateway.
DANGER
Electric shock hazard. Can cause personal injury or equipment
damage.
Prior to installing Intelligent Equipment hardware, power must be removed
from the unit. This means removing power at the breaker panel serving
the unit, and following proper lockout/tagout procedures at said breaker
panel for the duration of the install. Power should not be reapplied until all
electrical interconnections have been made and veried.
This equipment must be properly grounded. Connections and service to the
MicroTech II WMC Water Cooled chiller, MicroTech III Air Cooled Chiller,
Packaged Rooftop, or Outdoor Air Handling Unit Controller, Machine-to-
Machine Gateway and Energy Management Module must be performed
only by personnel knowledgeable in the operation of the equipment being
controlled.
CAUTION
Static sensitive components. Can cause equipment damage.
Discharge any static electrical charge by touching the bare metal inside the
control panel before performing any service work. Never unplug cables,
circuit board terminal blocks, or power plugs while power is applied to the
panel.
WARNING
Sharp edges on sheet metal and fasteners can cause personal injury.
This equipment must be installed, operated, and serviced only by an
experienced installation company and fully trained personnel.
Mounting
The antenna provided with the Daikin Applied Intelligent
Equipment solution (Figure 38) is omni-directional, and has
a swiveling base. The antenna should be oriented to avoid
interference from structures or other antennas. For initial
installation, it is recommended to install the antenna on top of
the chiller, rooftop, or air handling unit with enough clearance
from the edge to avoid accidental contact or damage. The
antenna is held in place by its magnetic base. You will nd
more information about aiming antennas in the sections, Wi-Fi
Conguration on page 31 and Troubleshooting on page
39 of this document.
Figure 38: Wireless Antenna on Magnetic Mounting Base
To Next Page
Loading...
