IM 1240-4 • INTELLIGENT EQUIPMENT 44 www.DaikinApplied.com
Appendix A
Wi-Fi or Hardwired LAN Ethernet connection Pre-Start-up Form
NOTE: This form must be completed in collaboration with site
IT sta prior to conguring the gateway for Wi-Fi or
Hardwired LAN Ethernet connectivity.
This form is not required for Cellular connectivity.
The Intelligent Equipment gateway is capable of
communicating via cellular connection, Wi-Fi connection, or
wired Ethernet LAN connection. For both Wi-Fi and wired
Ethernet LAN, the gateway supports DHCP to have an IP
address assigned automatically, or it can be eld programmed
with a static IP address.
If either Wi-Fi or wired Ethernet LAN is to be used for cloud
connectivity, the customer’s LAN Administrator should review
and supply the following information (as necessary) prior to
a technician going to the jobsite and commissioning the
gateway.
A CAT 5E Ethernet communication cable with an extra:
feet of coiled cable and a RJ45 connector on the
free end has been run per local codes from the customer’s
LAN to the unit main control box of each unit with an Intelligent
Equipment gateway.
1. IT Group must allow incoming and outgoing internet trac on TCP ports 80, 443, 3197, 3199, 5222, 5223 and 8080.
2. If the gateway will be required to use a static IP address the following information will need to be supplied:
Internal LAN Static IP Address: — — — (required)
IP Subnet Mask: — — — (required)
Default Gateway: — — — (required)
DNS Server (primary): — — — (required)
DNS Server (secondary): — — — (if applicable)
Proxy Server IP Address: — — — (if applicable)
Proxy Server Port Number: (if applicable)
3. For Wi-Fi Ethernet connections the following information will be required as well:
Wi-Fi network SSID:
Wi-Fi network password:
Wi-Fi encryption type:
Wi-Fi Mode:
Preferred Wi-Fi channel:
To Next Page
Loading...
