GB
74
Set of upper
detection
beams
Set of lower
detection beams
Anti-mask
selection dip
switch
Operating option
dip switches
Sensitivity
selection dip
switch
LED
Two 3 x 10 mm screws
(for fixing cover)
Two 4 x 20 mm screws (for
fixing box to adjustment bracket)
Test button
Lithium battery
connector
Programming
LED
Lithium battery
Radio card
Detection module
(front view)
Detection module
(rear view)
Angle adjustment
bracket
Cover
Sheet of adhesive masking strips
Bag of accessories
When the detector is switched on, the
LED flashes every second for 45 s
(detection circuit stabilisation period).
The programming LED lights up for 2 s.
Connecting the battery.
2.3 Power supply
d
Detection circuit
connector
IMPORTANT: if the LED does not flash,
check the connector is in the right
position (detection circuit).
To Next Page
