ENGLISH
104
Before you ask for servicing or repairs, check the following points.
TROUBLES AND CAUSES (Concerning remote controller)
Symptoms Causes Reason and Disposal
Setting Change is Impossible
The fan speed can not be changed. Check whether the MODE indicated
on the display is "AUTO"
When the automatic mode is selected,
the air conditioner automatically
selects the fan speed.
Check whether the MODE indicated
on the display is "DRY"".
When dry operation is selected, the air
conditioner automatically select the
fan speed. The fan speed can be
selected during "COOL" and "FAN
ONLY", and "HEAT"
The display goes off
The indication on the display disappe-
ars after a lapse of time.
Check whether the timer operation has
come to an end when the OFF TIMER
is indicated on the display.
The air conditioner operation stops
since the set time elapsed.
The ON TIMER indicators go off after a
lapse of certain time.
Check whether the timer operation is
started when the ON TIMER is indica-
ted on the display.
When the time set to start the air con-
ditioner is reached, the air conditioner
will automatically start and the appro-
priate indicator will go off.
The signal receiving tone does not sound
No receiving tone sounds fromthe
indoor unit even when the ON/OFF
button is pushed.
Check whether the signal transmitter
of the remote controller is properly
directed to the receiver of the indoor
unit when the ON/OFF button is
pushed.
Direct the signal transmitter of the
remote controller to the receiver of the
indoor unit, and then repeatly push the
ON/OFF button twice.
Buttons on the remote controller
don't work.
Press Reset button.
The display never comes on
The TEMP. indicator does
not come on.
Check whether the MODE indicated
on the display is "FAN ONLY".
The temperature cannot be set during
fan only operation.
The Transmission Indicator "G" never comes on
The remote control signal is
not transmitted even when
the ON/OFF button is pushed.
Check whether the batteries in the
remote controller are exhausted.
The remote control signal is not trans-
mitted, because the power supply is
off.
To Next Page
Loading...
