Daitsu APD-9CR - Care, Maintenance, and Troubleshooting; Important Precautions; Air Filter; Unit Enclosure

32
CARE AND MAINTENANCE
CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or
servicing.
2) Do not use gasoline, thinner or other
chemicals to clean the unit.
3) Do not wash the unit directly under a tap or
using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be
repaired by manufacture or its agency.
1. Air lter
Clean the air lter at least once every two
weeks to prevent inferior fan operation because
of dust.
- Removal This unit has two lters. Take the
upper lter out along the the arrow direction
(Fig.23),then take the lter down.
Remove the lower lter by loosening the screw,
taking out the lter as shown in Fig.23.
- Cleaning Wash the air lter by immersing it
gently in warm water (about 40ºC/104ºF) with a
neutral detergent. Rinse the lter and dry it in a
shady place.
- Mounting Install the upper air lter after
cleaning , and install the lower lter by using the
screw (see Fig.24).
2. Unit enclosure
- Use a lint-free cloth soaked with neutral
detergent to clean the unit enclosure. Finished
by a dry clean cloth.
3. Unit idle for a long time
- Remove the rubber plug at the back of the
unit and attach a hose to drain outlet. Place
the open end of the hose directly over the drain
area in your basement oor (See Fig.20 & 21).
- Remove the plug from the bottom drain outlet,
all the water in the bottom tray would drain out
(See Fig.22).
- Keep the appliance running on FAN mode for
half a day in a warm room to dry the appliance
inside and prevent mold forming.
- Stop the appliance and unplug it, wrapped
the cord and bundle it with the tape(Fig.25).
Remove the batteries from the remote
controller.
- Clean the air lter and reinstall it.
Upper lter
(take out)
Remove the
screw, then take
the lower lter
out
Upper lter
(install)
Install the lower
lter by using the
screw
Power plug
socket
Power plug
Power cord
Buckle
Fig. 24
Fig. 23
Fig. 25