9 MAN# 650666:A
DISPLAYS Message display option menu
Refer to graphic on page 3 for indicator and message locations.
• When “>DISPLAYS” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
• The display will show “MESSAGE TOP”, “MESSAGE BTM”, “MBMs”, or “BACK”.
• Press and release the switch to change the selection, press and hold the switch until “RELEASE” is displayed, and release.
MESSAGE TOP Top message screen information
• When “>MESSAGE TOP” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
• The selectable options are “PERFORM HIDE”, “PERFORM SHOW”, and “BACK”.
• Push and release the switch to select the option, press and hold the switch until “RELEASE” is displayed, and release.
• PERFORM HIDE: does not allow any performance option displays to be show while riding.
• PERFORM SHOW: turns all the following options that can be toggled through while riding.
o HIGH Speed (MPH – km/h), 0-60 time, ¼ mile speed with ¼ mile time, and HIGH RPM.
• Press and release the switch to change the change the option.
• Press and hold the switch until “RELEASE” is displayed, and release.
• Exit setup.
BTM MESSAGE Bottom message screen information
• When “>MESSAGE BTM” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
• The selectable options are “PERFORM HIDE”, “PERFORM SHOW”, and “BACK”.
• Push and release the switch to select the option, press and hold the switch until “RELEASE” is displayed, and release.
• PERFORM HIDE: does not allow any performance option displays to be show while riding.
• PERFORM SHOW: turns all the following options that can be toggled through while riding.
o HIGH Speed (MPH – km/h), 0-60 time, ¼ mile speed with ¼ mile time, and HIGH RPM.
• Press and release the switch to change the change the option.
• Press and hold the switch until “RELEASE” is displayed, and release.
• Exit setup.
MBMS Display which MBMs are connected and adjust warnings
If a pressure or boost sensor is not connected or failed, the display will show “FAIL”, “TOO LOW”.
If no MBM is attached but the display shows a blank value, click through the displays to remove it.
• When “>MBMs” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
• The screen display what MBM modules are attached and more than one input if it exists.
• The screen will show “NONE” if there are no MBMs present.
• Press and release the switch to move through the MBMs attached.
• Press and hold the switch until “RELEASE” is displayed on the MBM setting to modify.
o See the separate MBM manual for additional details.
• Exit Setup.
To Next Page
Loading...
