DALI White Wave cables - the perfect choice for Suite R 0.7/0.8
9
English
Connection to a stereo pre-ampli er (Fig. 6)
If you want to use Suite S 1.2 to supplement the bass reproduction of a
stereo system, connect the subwoofer "Line in, Left/Right" to a stereo
signal on the pre-ampli er with full frequency content. The built-in crosso-
ver network in Suite S 1.2 then ensures that the subwoofer only reproduces
the lowest frequencies (see section on adjustments on page 10).
In most cases you will achieve excellent results with one Suite S 1.2. It is
possible as a no-compromise stereo solution, or for reproduction of very
powerful sound pressure in a surround set-up in large rooms, to use two
Suite S 1.2. This solution is connected in the same way, but for stereo you
should only connect the left-hand channel to one input terminal on the
left-hand Suite S 1.2 and the right-hand channel to one input terminal on
the right-hand Suite S 1.2. For a surround set-up, parallel the LFE-inputs of
the two Suite S 1.2. In all other respects, follow the instructions above - but
use separate channels. You may wish to consult your dealer.
Note: When using two Suite S 1.2, the best results are normally achieved
by positioning the two subwoofers relatively close to each other (1 - 2
To Next Page
Loading...
