3
Verify integrity of the unit after removing packaging material. If any doubt exists about its integrity, abort
installation. Packaging material should be kept away from children as it may represent a danger. Place the
machine on a suitably strong counter top and adjust the feet of the unit until it is perfectly fixed
Before connecting the machine, make sure the capacities of the electrical and water hookups are enough to
handle the requirements of the machine as indicated on its Data Tag.
ELECTRICAL SYSTEM
Machine is provided with power cord without plug. Connect machine to electrical circuit, using a sectional
connector allowing omni-polar disconnection of unit from circuit. Insure that the leads of such connector
are distanced at least 3 mm from each other.
The operation described here above can be performed in two ways:
- Connection to electrical circuit via suitable connector
Perform installation in accordance with local laws and regulations, and follow the instructions provided below.
Manufacturer can not be held responsible for damages to humans, animals or objects caused by an incorrect
installation.
This machine must be not installed in area where a water propulsion jet is present.
Machine’s installation, using and maintenance must be made only by by qualified staff .
The ambient temperature must be at least 10 °Degrees C and a maximum of 25 °Degrees C .
INSTALLATION
ATTENTION
Machine weighs over 30 kg; therefore it should be lifted by two or more people
LEGEND
1. Cold water tap
2. Flexible water hoses
3. Water softene (optional )
4. Drain hose
5. Floor sink
6. Electric cord
7. Circuit breaker / Powere switch hose
1
3
2
4
5
6
7
To Next Page
Loading...
