dallmeier DMS 2400 - Approvals and Certifications; Mainboard Battery Handling

11
SERVICE – DMS 2400 (MK 3) | REV 1.0.0 | © 2022 Dallmeier
Approvals/Certications
The following approvals/certications were valid for the device at the time
of this document’s compilation:
•
CE / UKCA
•
FCC
•
DIN EN 50130-4
Visit www.dallmeier.com for possible updates.
Mainboard Battery
Important basic functions (e.g. time and hardware settings) can be obtained
from a battery on the main board of the appliance. If the battery is emptied
after a certain time (3-6 years), it may cause interference during the boot
process: The appliance will not start after a complete shutdown.
The battery on the mainboard must be replaced only by authorized person-
nel.
Contact the Dallmeier service department for an exchange.
CAUTION
Injury due to explosion hazard!
➡
Replace the battery on the main board always by a battery of the same
type.
➡
Dispose of used batteries according to the present instructions.