Serie "LXS9"
Pagina A - 18
If errors should be detected during the check, the check itself stops and the following message appears:
Where “xxxxxx” is the detected error. See the “Installation and service” manual, "Problems and relative
solutions” chapter, “Motor anomaly messages” section for the list of anomalies and relative solutions.
From these error conditions it is possible to make the check sequence continue by pressing the F key, or
end it with the A key.
One of the following messages will appear at the end of the check sequence:
This means that anomalies and/or differences between the current configuration and the one detected
during the last self-learning procedure have been detected; XX indicates the number of the currently
recognised motors.
This means instead that anomalies and/or differences between the current configuration and the one
detected during the self-learning procedure have not been detected; XX indicates the number of the
recognised motors.
In the event of “Check OK”, at the end of the motor check cycle the vending machine‟s original
configuration is completely restored and the out of orders reset.
N.B.: at each check the motors rotate just a few degrees; therefore, repeating the check several times in
succession, the motors could lose alignment; we therefore recommend realigning the motors, for example
by carrying out a manual motor test, as described previously in this manual.
> MOTOR SELF-LEARNING:
Select this item to repeat the self-learning of the motors present in the vending machine; this action is only
allowed if a password is set in the protected parameters menu.
Check OK
Conn. motors: XX
Check incorrect
Conn. motors: XX
Self-learning
Conn. motors: xx
To Next Page
Loading...
Need help?
General
