Danby DDR4007EE - Care and Maintenance, and Trouble Shooting Guide

|ADR3006==.cjxp 2006.02. n 13:41 Page 26
Care and Maintenance
Cleaning
CAUTION: Before attempting to dean and/or service
this unit, always disconnect the power supply cord from
the electrical power supply/oullet,
1. DO NOT use gasoline, benzene, paint thinner, or any
other chemicals to clean this unit, as these substances
will damage/detorm both plastic components and luster
finish.
2. Never attempt to dean the unit by pouring water
directly over any of the sudace areas, as this will
cause deterioration of electrical components and wiring
insulation.
Storage
When the dehumidifier is not being used for long time
periods, please follow these instructions,
1. Disconnect the power cord from the power supply.
2. Empty the water tank and wipe (clean) thoroughly.
3. Clean air filter thoroughly
4. Re-package the unit in the original carton,
5. Store the unit upright in a dry location.
3. U se only a mild dish washing detergent, lukewarm
water and a soft cloth to wipe the exterior surface of
the unit and dry thoroughly.
TROUBLE SHOOTING GUIDE
Frequently, some problems are of a minor nature and a
service call may not be necessary. Use this
troubleshooting guide to identify possible problems you
may be experiencing. If the unit continues to operate
improperly, cal! your local Danby’^Service Depot or 1-800-
26-DANBY (1-800-263-2629)
for assistance.
PROBLEM POSSIBLE CAUSE
Unit will not operate.
Check power cord connection.
Check electrical outlet for blown fuse.
Check if water tank is full (empty).
Check water tank is properly installed.
Dehumidifying capacity
Air filler is dirty and/or blocked.
(moisture removal) low.
Ambient room temperature too low. (below s5C/4l F)
Poor airflow circulation / obstruction of front grill.
Relative Humidity in surrounding environment very low,
j Relative Humidity setting not ‘I
reached after iong period of
Check all doors and windows are closed.
operation.
Area/room is too large for the capacity of the dehumidifier.
4
I
11