Danby DPAC7008 - Setting the AUTO-ON TIMER; Setting the AUTO-ON & OFF timer

Setting the AUTO-ON TIMER
You must select all appropriate settings required to
operate under the AUTO TIMED program before ini-
tiating the AUTO-ON program;
• Select the appropriate MODE under which
you want the unit to operate (Cool,
Dehumidify or Fan).
• Select the appropriate FAN SPEED set-
ting, under which you want the unit to
operate; Hi, Medium or Low. (excluding
Dehumidifying, as this mode has one
(1) pre-set fan speed setting only).
• To set the AUTO-ON timer, the unit must
be turned “off” (non-operational).
1) Press the (on/off) key pad to switch on the
unit.
Fig S
2) Select all appropriate operational settings (see
listing above).
3) Press the (on/off) key pad to switch the unit
off. Fig S
4) Press the TIMER-ON key pad ( Fig T) to initi-
ate the AUTO-ON time sequence. The “AUTO-
ON” indicator light (
Fig U) will illuminate on the
control panel and the timer digits ( Fig V) will
appear in the display window.
5)
Continually depress the key
t o adjust Timer On
settings
forward by 0.5 hour increments (0.5 ~ 24
hours).
6) To view the timer setting at any time; press the
TIMER-OFF key pad again and the timer
length you selected will be shown in the display
window.
• The unit will start automatically at the specified
AUTO-ON set time.
• To cancel or override the AUTO-ON program,
simply turn on the unit anytime prior to when the
AUTO-ON time is scheduled to operate.
Setting the AUTO-ON & OFF timer
Follow the above steps to set the auto-on timer then
proceed to set the auto-off timer (see page 11).
When setting the auto-on and auto off timer, the
operation (running) time of the unit is the difference
between the auto-on and auto-off set timer lengths.
For example,to have the unit automatically power on
two hours from now, then operate for one hour and
power off; Set the auto-on timer length to 2 hours,
and set the auto-off timer length to 3 hours, this sets
the timer program for 1 hour of operation.
11
M
O