Dane Technologies, Inc. QuicKART 2000 Owner’s Manual
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com 970-026 rev 3-1-06
64
QuicKART 2500 IMPORTANT OPERATING PROCEDURES
(Optional Transparency and/or Handout)
Review of procedures for trainees:
1. Before operating the QuicKART, check to be sure all tires look in good condition,
check that the light is flashing, steering is ok and brake works. If any problems are
identified, do not operate machine--remove key and notify supervisor.
2. When proceeding down a sloped lot with a chain of carts, walk to the side of the
front cart and hold back on the lead cart or use strap to prevent carts from
separating. Proceed at a pace that will allow you to stop carts fairly quickly should
the need arise.
3. Never stand or walk in front of carts being pushed or attempt to stop carts by
standing in front of a chain of carts.
4. When passing through a narrow area with chain of carts, allow enough room
between carts and any fixed object so that you don’t become wedged between them.
5. Never allow anyone to ride on shopping carts when collecting carts. Slowly stop the
QuicKART and politely ask the person to get off.
6. When approaching employees or customers with a chain of carts, slow down and
allow them to pass where possible; otherwise, politely indicate, “Excuse me please,
cart collection passing through. Thank you.”
7. The person who is directing the chain of carts must always be in possession of the
remote control transmitter and in control of the speed of the QuicKART and chain of
shopping carts.
8. Never attempt to “steer” a line of carts by using the handles on the machine. Always
use the remote control and lead from the front when two or more carts are loaded at
the front of the QuicKART.
9. If for any reason the QuicKART does not stop properly or is not completely under
your control, press the emergency shut-off button on the control panel, remove key
and notify your supervisor immediately.
10. When battery level on the QuicKART control panel indicates 20% or less, drive it to
the designated parking area and plug it into the electrical receptacle for recharging.
This will help to keep the batteries charged. Parking area must be in a large, well-
ventilated area to prevent buildup of explosive hydrogen gas. Do not smoke or
permit any open flame or spark sources nearby when charging batteries.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
To Next Page
Loading...