Dane Technologies, Inc. QuicKART 2000 Owner’s Manual
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com 970-026 rev 3-1-06
72
QuicKART 2000 QUIZ
Your Name: ______________Date: _______ Store Location: _________________
1. The approximate maximum number of shopping carts that should be pushed by the QuicKART is:
A. 10 B. 20 C. 30 D. 50
2. While directing a chain of carts using the QuicKART, the operator should walk to the side of the lead
cart and hold it back to prevent the carts from separating and also enable them to be stopped promptly.
True _____ False _____
3. The QuicKART can be used to push a chain of shopping carts into the cart room. True ___False __
4. When approaching customers or employees with a chain of carts being pushed by the QuicKART
proceed toward them at your normal operating speed. True _____ False _____
5. During manual operation, the brake on the QuicKART is applied by releasing the throttle grip.
True _____ False _____
6. Before beginning to use the QuicKART, be sure to check (select only one)
A. The condition of the tires. D. Flashing light is working.
B. Battery charge level is greater than 20%. E. All of the above.
C. Brake for proper operation.
7. When manually operating the QuicKART, it’s acceptable to operate several carts attached to the front
of the machine. True _____ False ________
8. The QuicKART can be driven off curbs and on grass surfaces. True _____ False _____
9. When the QuicKART is to be left unattended or in storage, turn it “OFF” and remove the key.
True_______ False_______
For each item below, identify its location on
the control panel in Figure 1 and write the
appropriate letter next to the item.
ITEM DESCRIPTION Letter
10. Direction Selector Button
11. Key Switch
12. Charge Level Indicators
13. Manual/Remote Selector
14. Horn
15. Emergency Shut-Off
Number Correct:______
--------------------------------------------------------------------------------------------------------------------
To be completed by trainer.
PERFORMANCE TRAINING
Observe the associate perform the following tasks and indicate if he/she displayed acceptable operation.
For successful completion of training associate must display ability to properly perform all three operating
tasks:
Control Panel Use Manual Operation of QuicKART Cart Collection in Remote
Ok __ Unacceptable __ Ok __ Unacceptable __ Ok __ Unacceptable __
Trainer: Date:
If performance training was not successfully completed, do not allow the associate to operate machine on
their own until retrained and re-evaluated. If re-evaluated, make note below.
Note:
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
To Next Page
Loading...