9VI.UH.R1.80
Produced by Danfoss Floor Heating Hydronics 01.2006
Instruction CF-RF Room Thermostat with InfraRed Floor Sensor
IMPORTANT!
As heat emission from the oor may vary slightly
depending on oor covering - and thereby cause
inaccurate temperature measurement - it may be
necessary to adjust the setting of max. and min.
oor surface temperatures accordingly.
! It is important always to follow recommendations
from the oor manufacturer regarding max. oor
surface temperature.
! It is recommended always to include mixing shunt
for oor heating circuits in order to ensure optimal
ow temperature. - In addition to minimised energy
consumption, correct setting of the ow tempera-
ture will eliminate the risk of excessive heat transfer
to the oor.
To Next Page
Loading...
