10
Example:
If you want your system ON between 8am and 10am and again
between 4pm and 11pm, set the tappets as shown. (A to 8, B to
10, C to 16, D to 23).
Remember:
Red tappets (A and C) switch ON
Blue tappets (B and D) switch OFF
3. Ensure that the installer has removed the protective tape
covering the pre-selector wheel.
4. Using the dial knob, rotate the dial completely at least
twice, clockwise only, to clear the mechanism.
Note: Tappets can be moved around the dial in a clockwise or anti-
clockwise direction, as convenient.
Setting the programme
Remem
To Next Page
Loading...
