Danfoss 3060

8
Using the Programmer
Theselectorswitchisusedtoselecthowthe3060controls
yourhotwaterandheating.Theheatingandhotwatercanbe
operatedtogetherinvariouscombinations,orthewatercan
becontrolledonitsown(i.e.duringthesummerwhenonly
hotwaterisrequired).
Therearesixpositionsintowhichtheselectorswitchmay
beset.
1 - H OFF / W OFF
 BothHeatingandHotWaterwillremainOFFuntilyou
changethesetting.
2 - H TWICE / W TWICE
 InthispositiontheHeatingandHotWaterwillboth
comeonandgooffaccordingtothetimesyouhave
programmed(ONatA,OFFatB,ONatC,OFFatD).
3-H ONCE / W ONCE
 ThissettingoverridestappetsBandC,soboth
HeatingandHotWaterwillswitchONatthetime
markedbytappetAandwillstayonuntilthetime
markedbytappetD.Bothserviceswillthenswitch
OFFuntil‘A’thenextday.
Using the programmer
H+W
ON
H+W
OFF
H - TWICE
W - ONCE
H - ONCE
W - ONCE
H - TWICE
W - TWICE
H - OFF
W - TWICE