Danfoss CET B-RF - Commissioning Instructions; Pairing and Initial Setup

15
Commissioning Instructions
If the thermostat and receiver have been supplied together
in a combined pack the units have been paired in the factory
and no commissioning is required (RX1 only).
Step 1 Ensure that the power to the
RX1 is turned on and that the
programmer is calling.
Step 2 CET B-RF
Turn the thermostat dial so
the widest end of the setting
line is lined up with the LCD
display (see opposite).
Remove dial, press & hold
LEARN button for 3 seconds
(located under setting dial).
Do not replace the setting dial yet.
Commissioning
CET B-RF
RF
LEARN
For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk