To Next PageTo Next Page
What to do if my Danfoss Gateway indicates a communication error on the ECL?
If your Danfoss Link™ indicates a communication error on the ECL and the DLG for ECL has a green light, it might be caused by an unstable or disconnected cable connection between the ECL and the DLG. Check the cable connection for defects. Fasten the screw terminals, and if the error persists, the cable has to be changed.
Why is my Danfoss Gateway room temperature too low?
If you are experiencing low room temperature (below comfort settings) with your Danfoss Gateway, it might be because the ECL controller is left in setback due to a lost connection. Alternatively, if the connection is okay, check the heat curve slope setting of the ECL controller and increase it if necessary.
What to do if Danfoss Link™ Control Systems indicates a communication error on the ECL, but the DLG for ECL has a green light?
If your Danfoss Link™ Control Systems indicates a communication error on the ECL while the DLG for ECL shows a green light, it might be due to an unstable or disconnected cable between the ECL and the DLG. Inspect the cable for any defects and tighten the screw terminals. If the problem continues, you may need to replace the cable.
Why is my room temperature low (below comfort settings) with Danfoss Link™ Control Systems?
A low room temperature (below comfort settings) when using Danfoss Link™ Control Systems may be because the ECL controller is left in setback due to a lost connection. If the connection is stable, verify the heat curve slope setting of the ECL controller and increase it if needed.
How to fix impossible to add device, ECL, to the Danfoss Link™ CC system?
If you're unable to add an ECL device to the Danfoss Link™ CC system, first ensure that the MODBUS address of the ECL controller is set to 5. Also, check the software version of your Danfoss Link™ CC (house control/settings/about) and update it if it's older than MkIII 3.2.
What does a flashing LED on DLG mean for Danfoss Control Systems?
A flashing LED on the DLG indicates that the CC is disconnected or the wireless signal is weak.
General| Communication Protocol | Modbus RTU |
|---|---|
| Display Type | LCD |
| Mounting Type | DIN rail |
| Digital inputs | 4 |
| Relay outputs | 2 |
| Analog inputs | 2 |
| Enclosure rating | IP20 |
| Power Supply | 24 V AC or 24 V DC |
| Temperature Range | 0 to 50 °C |
| Application | Heating systems |
| Inputs | Pt1000 |
| Outputs | Relay |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -20 to 60 °C |
