Danfoss EKC 223 - Installation Steps and Dimensions

Installation steps
• Place the wired controller in the slot and ensure rubber sealing is resting properly on the mounting surface.
• Slide the mounting clips along the rails of the rear plastic from the rear side of the panel.
• Slide the clips towards mounting surface until controller is rmly xed.
• To remove the controller, unlatch the snapping tab and pull the clips backwards.
Dimensions
Figure 24: Dimensions (mm)
83
66
Rear mounting (lock with clips)
Drilling template
61.2
28
36
71
29
Danfoss 80G8390
© Danfoss | Climate Solutions | 2023.05 BC432222569027en-000201 | 35
Case controller, type EKC 223 and EKC 224