8
Commissioning (RF only)
If the thermostat and the receiver have been supplied
together in a combined pack, the units have been paired in
the factory and no commissioning is required (RX1 only).
Step 1 RET B-RF
Position the setting dial to number
1. Remove dial, press & hold LEARN
button for 3 seconds (located under
setting dial).
Do not replace the setting dial yet
NOTE: Thermostat now transmits
signal continuously for 5 mins.
Step 2 RX1
Press and hold buttons PROG and CH1 until green light
ashes.
LEARN
Installation Instructions
GB
To Next Page
Loading...
Need help?
General
