Danfoss TP4 - Changing the preset programmes - TP4

16
Changing the preset programmes - TP4
a) Press PROG twice to show the
1st pre-set time and temperature
(Event 1).
b) Use + or – buttons to adjust the
TIME (press and hold to change in
10 min increments).
c) Use  or  buttons to adjust the
TEMPERATURE.
d) Press PROG to move to next preset
time & temperature (Event 2).
e) Repeat steps b, c & d for
programming Events 3, 4, 5 & 6.
User Instructions
GB