3
Please Note:
This product should only be installed by a quali ed
electrician or competent heating installer, and should be
in accordance with the current edition of the IEEE wiring
regulations.
Speci cation 230V Model 24V Model
Power supply 230 Vac, ±15%,
50/60 Hz
24Vac, ±15%,
50/60Hz
Switching action
1 x SPDT voltage free, Type 1B
Switch rating 24 - 230 Vac, 3(1)A
Battery back-up 24 hours minimum
Setting/Running Accuracy ±1 minute
Dimensions, mm (W, H, D) 135 x 88 x 32
Design standard EN 60730-2-7
Control Pollution Situation Degree 2
Rated Impulse Voltage 2.5kV
Ball Pressure Test 75°C
Product speci cation
Installation and Speci cation
Installation Instructions
Installation
Remove wallplate from unit by unscrewing the two screws
on the bottom edge of the unit.
From the top left hand corner of the wallplate, there must
be clearances of at least 140 mm to the right, 15mm to the
left, 30mm above and 100mm below in order to mount
the plug-on module.
To Next Page
Loading...
Need help?
General
