FCM 300 / FCD 300 / VLT
®
2800 / DP V1 PROFIBUS
Introduction
The Profibus DP V1 replaces the former
Profibus DP V0 functionality.
Note: The 3MB and 12MB Profibus option are separate
options and have different ordering numbers.
■ What you should already know
The DANFOSS PROFIBUS is des igned to communicate
with any master abiding by the PROFIBUS DP
standard. It is therefore assumed that you have full
knowledge of the PC or PLC you intend to use as
a m aster in your system. Any questions pertaining
to hardware or software produced by any other
manufacturer is beyond the scope of this manual
and is of no concern to DANFOSS.
If you have questio ns about how to s et up master
- master communication or communication to
a non-Danfoss slave, the appropriate manuals
should be consulted.
MG.90.A5.02 - VLT is a registered Danfoss trademark
3
To Next Page
Loading...
Need help?
General