Danfoss VLT 2840 Manual

VLT® 2800 Series
Installation
■ VLT Software Dialog
Connection to terminals 68-70 or
Sub D:
-PIN3GND
- PIN 8 P-RS 485
- PIN 9 N-RS 485
■ Sub D plug
An LCP 2 control unit can be connected to the Sub D
plug on the control card. Ordering number: 175N0131.
LCP control units with ordering number 175Z0401
are not to be connected.
MG.28.A8.22 - VLT is a registered Danfoss trademark
21

Danfoss VLT 2840 Specifications

General

Brand	Danfoss
Model	VLT 2840
Category	DC Drives
Language	English