Need help?Do you have a question about the Danfoss VLT 3542 and is the answer not in the manual?
General| Input Voltage | 380-480 VAC |
|---|---|
| Protection Class | IP20 |
| Enclosure Rating | IP20 |
| Control Method | Vector Control |
| Communication Interfaces | CANopen |
| Supply Voltage | 380-480 VAC |
| Output Current | 730 A |
| Control Mode | Speed, Torque, Position |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature |
Warning about touching electrical parts after power disconnection.
Drive must be disconnected, grounding correct, and Stop/Reset key limitations noted.
Motor start conditions during programming, faults, or reference changes.
Parameters for display, local operation, and setup handling.
Parameters for tailoring drive to load and motor characteristics.
Parameters defining operating conditions and drive limits.
Parameters for stop/start conditions and time delays.
Parameters for drive response to inputs and outputs to devices.
Parameters for drive response to serial communication.
Parameters for diagnosing operation and service issues.
Flowcharts to diagnose common problems like motor unevenness or no run.
Essential precautions to prevent damage from static electricity.
To Next Page