Need help?Do you have a question about the Danfoss VLT 3552 and is the answer not in the manual?
Core safety practices and precautions for operating the drive.
Critical safety information regarding potential motor start-up hazards.
General guidelines for installing the VLT Series 3500 drive.
Installation details specific to VLT models 3502-3562 and 3575-3700.
Instructions for connecting the main power supply to the drive.
Recommendations for using shielded cables to reduce interference.
Specifies the required fuse types and sizes for drive protection.
Illustrates common wiring configurations for line and motor connections.
Steps for connecting standard three-phase motors to the drive.
Visual representation of terminal block locations on the drive.
Lists functions that can be assigned to drive terminals.
Explains the function and purpose of each control card terminal.
Setup for controlling fan speed using a potentiometer.
Setup for a ventilating system with fire safety reversing.
Setup for fan control with thermistor and potentiometer.
Setup for pump control with 3-wire start/stop and current feedback.
Setup using PLC digital signals for frequency control.
Setup for ventilation system with multiple preset speeds.
Setup for pump system using PID pressure control.
Setup for ventilation system using PID temperature control.
Setup for remote Hand/Off/Auto control functionality.
Details on reset, alarm, and fault messages and their meanings.
Guide to diagnosing common drive issues starting with basic checks.
Further diagnostic steps for complex drive problems.
Concluding steps for resolving drive faults and alarms.
Essential precautions for handling electronic components safely.
To Next Page
General