message. The resulting retransmissions of messages
will slow communications on the network.
If this value is set too long, the drive will wait longer
than necessary to determine that the message is com-
pleted. This will delay the drive’s response to the mes-
sage and possibly cause the master controller to time
out. The resulting retransmissions of messages will
slow communications on the network.
VLT
®
5000 Series
= factory setting, () = display text, [] = value for use in communication via serial communication port
MG.51.C5.22 - VLT
p
is a registered Danfoss trademark. 147
Programming
To Next Page
Loading...
Need help?
General
