P I 02 9604 1226 E I sales@danielaappliances.com.au W | danielaappliances.com.au
PAGE 10
General tolerance for fitting dimension:
Width: 560+/-1,5mm
Height: 589 +0-2,5mm
Fig. 1
Fig. 2
N.B. Buildimg-in for gas hobs mod
(...32...P....) Polyvalents
IMPORTANT
• Position the mains supply cable so that it is never subjected to a temperature which is more
than 50 above ambient temperature.
• The electrical safety of the appliance can only be guaranteed when it has been correctly
connected to an ecient earthed power supply, as laid down in the regulations for
electrical safety.
• The manufacturer cannot be held responsible for any damage to persons or objects due to
lack of an earth connection.
To Next Page
Loading...
