EasyManua.ls Logo

Daniela DAN5TFS - Connection to the Mains Supply; Mains Supply Connection Guidelines

Daniela DAN5TFS
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P I 02 9604 1226 E I sales@danielaappliances.com.au W | danielaappliances.com.au
PAGE 9
THE YELLOW/GREEN EARTH WIRE SHOULD NOT BE CONTROLLED BY THE SWITCH.
The plug or a double pole switch used for mains supply connection should be easy to get at,
once the appliance is in position.
CONNECTION TO THE MAINS SUPPLY
THIS APPLIANCE MUST BE CONNECTED IN ACCORDANCE WITH THE RULES CURRENTLY.
IT CAN ONLY BE INSTALLED BY A LICENSED ELECTRICIAN OR A CERTIFIED DANIELA
APPLIANCES PTY LTD TECHNICIAN OR SERVICE AGENT.
WARNING
The oven is only for domestic use.
The feed voltage and the absorbed power are as indicated on the data plate attached to
the left-hand side upright, which can be seen when the oven door is open.
Connecting must be carried out by qualified personnel and in accordance with the
regulations currently in force.
The manufacturer cannot be held responsible for any damages to persons or objects
caused by failure to observe these instructions.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
The plug should be accessible after installation. Fit the plug into a socket fitted with a third
contact which corresponds the oven. The hob must have a rear gap of at least 45mm.
Fig. 4 Fig. 5

Related product manuals