DB-70 Automatic Wheel Balancer 12 P/N 5900261 — Rev. A1 — January 2021
Tools
You may need some or all of the following tools:
• Forklift, pallet jack, or shop crane
• Scissors, utility knife or other cutting tool.
• Hammer, mallet, crow bar, or pry bar
• Hex key and wrench set, metric and SAE
• Screwdriver set, slot and Phillips
Finding a Location
Keep the following in mind when deciding on a location for your Balancer:
• Power Source. The Wheel Balancing Machine needs to be near an appropriate 110 or 220 VAC
power source.
• Floor. The Wheel Balancing Machine requires a flat, concrete floor.
• Clearance. The DB-70 needs 5 m
2
space around it. Refer to Clearance for more information.
• Access. You need some space to move Wheels to and from the Wheel Balancing Machine.
• Danger. When the Wheel Balancing Machine is in use, especially during Balancing, you need to
keep everyone away from it. Only the Operator should be within 30 feet of the Wheel Balancing
Machine when it is in use.
Do not set-up the Wheel Balancing Machine in a well-travelled area.
• No Water. The Wheel Balancing Machine has electronic components. If the Wheel Balancing
Machine gets wet while turned on, those electronic components may short circuit and have to be
replaced.
⚠ WARNING
Do not use the Wheel Balancing Machine if it is in water.
You will short
circuit the electronic components in the Wheel Balancing Machine and you could
electrocute yourself or bystanders.
To Next Page
Loading...