DB-70 Automatic Wheel Balancer 27 P/N 5900261 — Rev. A1 — January 2021
6. Return the inner measurement arm to its rest position.
A –b- should now be flashing in the Inner Window. Manually determine the width of the Tire using
the wheel caliper, and then enter this value using the + and — buttons above and below the B key
on the Control Panel.
Note: If you start balancing a Wheel without entering one or more measurements, the Balancer
will use default values for any measurement you did not enter. The Balancer will spin and
weight to be added for correction will appear, but without correct measurements it is
virtually guaranteed that the balance will
not
be accurate.
To Next Page
Loading...