PAGE 52 46210/46220-0998 <90-00036>
This example would set control point 32 (point 16 of subgroup 2)
for 10 seconds.
Output Response:
The output response is the same as the CPM POINT SET
command.
DELAY
Purpose:
When an alarm occurs, there is a delay before the 46210/46220
will recognize the alarm to filter out spurious alarms. The delay
can be set for either 200 or 500 milliseconds.
Format:
DELAY
SG # DELAY 200
SG # DELAY 500
Remarks:
The command DELAY shows whether the delay is set for 200 or
500 milliseconds. The other commands set the delay time period.
# can be a range of subgroups from 1 through 16. The number
can be a single number or a range of numbers.
Input Example:
>SG 3 DELAY 500
This example would set a 500-millisecond delay before recogniz-
ing alarms on inputs 33-48 (subgroup 3).
PRINTER SYNTAX
To Next Page
Loading...
