6
EN
099241 • Version 1.2 • 08.02.2019
14.
• Use an empty USB memory dongle.
• Format the USB memory dongle til FAT32 le system. ( Details below)
• Download the latest software version from URL: ftp://ftp.dantherm.com/DEHUMIDIFICATION/CDP 40-
50-70 - various documentation/Software/
and copy the le to the USB memory dongle.
• Insert the USB memory dongle in the USB port of the controlpanel of the unit.
• The unit will now auto detect the new software and install it.
•
The installation process should take no more than 30 seconds.
In the process a log le is stored on the USB memory dongle.
If you wish to read the log le but not update the software, just insert an empty FAT32 USB memory dongle
and a log le will be downloaded.
How to format
a USB memory
dongle to
FAT32:
• Insert a USB memory dongle in the USB port of the computer
• Press WIN key( )+r
• Type: CMD - hit enter
At the promt type: format /FS:FAT32 H: and hit enter.
The letter H is the drive letter.
Note: In the format process all data on the USB memory dongle will be erased.
+v
TH
TH
GND
GND
+
GND
+
RH
ON
ON
USB RS485
EXT RH/T ALARM 12V DC
RUN FAIL HEAT1 HEAT2
GND
+
GND
+
RH
ON
ON
OK
Download and install latest software version
To Next Page
Loading...
Need help?
General
