21
EN
Condensate outlet The condensate outlet is located at the base of the dehumidier. The unit has a drain spigot
intended for connection of a ¾’’ exible or xed water hose or simply dripping. If you choose to
have the outlet through the wall, a matching hole is made in the wall and the drain is
connected to the dehumidier before it is placed on the wall suspension bar.
It is important that the hose from the dehumidier to the drainage has a drop of at least 2 % to
make sure that the water runs away from the condensate tray.
Alternatively a condensate pump can be tted at the water outlet to pump the water to a drain.
The position of the condensate outlet is shown on the drawing – the unit is seen from below.
Connection of power supply Power must be connected to the unit in accordance with the values stated on the name-plate.
Please see wiring diagrams starting on page 327.
The AC mains must be connected as shown below.
CDP
CDP-T
Mounting and installation instructions CDP and CDP-TContinued
2,5 mm
Min Ø9
Max Ø18
Note:
It is the responsibility of
the installer to ensure
the conformity towards
national regulations of all,
not supplied cables.
To Next Page
Loading...
Need help?
General
